Devloper123's Forums

Welcome to

Dev123's pic

's forums!

You are not logged in.



#1 2018-05-18 08:11:25

New Dev
Registered: 2018-04-13
Posts: 9
Dev Dollars: 27
Bank: 0

HMN4079D Programming Issue


HNM4079D on XTL5000 O5 Control Head
Model M20QSS9PW1AN
Flash: 580208-001C80-9
Firmware 12
CPS 12
When I try to program the three side buttons, the radio ignores what I program:
Upper/No-dot program as Scan gives me Unpr
Middle/1-dot program as ZnDn gives me Unpr
Bottom/2-dot program as ZnUp gives me Unpr
No matter what combinations I try, it does not take. Sometimes the Upper and Middle keys program but not correctly. The bottom 2-dot key never programs. I have tried programming the Trunk Side the same as the Conventional Side and also leaving the Trunk Side unprogrammed. The radio is used for Conventional only.
Do I have to tell the radio that there is an HNM4079 attached? How?

Any help will be apprecited.

I didn't find the right solution from the Internet.

Blockchain Advertising

Thank you.



2018-05-18 08:11:25



Board footer

Powered by FluxBB
Hosted by PunBB-Hosting